You will still need to wiggle the Logger back and forth to induce it to release its grip. If you do use pliers, be careful, and only grip where indicated.You can use a pair of long nose pliers to assist if your grip strength gives out before the Logger pins do.Eventually, it will loosen up and come out.Grip it where indicated on the Logger and wiggle. Remove the ethernet cable from the Logger.Unplug the AC power cable from the rear of the console.You will then be able to easily remove the first battery.The easiest way to do this is to pull back on the second battery, relieving pressure on the first battery.Turn the console over and remove the battery cover.This will change the screen to display SERIAL BAUD RATE 19200.This will enter setup mode on the console and the screen will display RECEIVING FROM.On the Davis console press DONE and the minus button (-) at the same time. How to reset the Logger (in 20 easy steps) In order to clear the buffer you have to reset the Logger. The WeatherCat Log available under Tools will indicate the various weather data components are not ready. However, no data is being received by your Mac. When this happens, you will still see the status light on the Logger itself flashing green, indicating data is being sent from the Vantage console. Depending on how long the Logger buffer has been stuck, you may even see thousands of Comms Errors in the Cat. Sometimes, the buffer in the WeatherLinkIP™ data logger (hereinafter referred to as the Logger) gets "stuck." When this occurs, WeatherCat will start recording multiple, consecutive Comms Errors. This page refers to the original Davis WeatherLinkIP™ data logger (product number 6555), which has been discontinued and which is NOT the same thing as the currently marketed Davis WeatherLink Live wireless logger.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |